Logo

ASTM D4778-05

Historical Revision

Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions (Withdrawn 2024)

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This test method provides directions for fabricating and operating a test apparatus to simultaneously monitor the corrosion and fouling tendency of real and pilot cooling water systems under heat transfer conditions.

1.2 Interpretation of the results of this test method must be left to the investigator. Many variables are involved which may not be easily controlled or fully understood. Variations in design and operating conditions may produce results that are not comparable from unit to unit.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


Deposits on heat transfer surfaces reduce efficiency of the heat exchanger affected. A method for easily determining the corrosion and fouling tendency of a particular water under heat transfer conditions will allow the evaluation of changes in the various system variables such as heat flux, flow velocity, metallurgy, cycles-of-concentration, and treatment schemes on heat exchanger performance.


Note—All pipe is threaded 1 in. (25 mm) PVC. Heater should be fused and grounded in accordance with local electrical codes.

FIG. 1 Test Apparatus and Parts List


Parts List:
(1) test specimen (6) acrylic tube, 10 in. (25 cm) long by 1 in. (25 mm)
outside Diameter
(2) tube fitting; nylon (no metal parts) (7) Cartridge type heater (not shown)
(3) reduci ng bushing, PVC
(4) tee, 1 in. (25 mm) PVC
(5) tube fitting, 1 in. (25 mm) tube by 1 in.
(25 mm) male pipe thread stainless steel
FIG. 2 Test Assembly and Parts List

SDO ASTM: ASTM International
Document Number D4778
Publication Date Jan. 1, 2005
Language en - English
Page Count 5
Revision Level 05
Supercedes
Committee D19.03
Publish Date Document Id Type View
July 1, 2024 D4778-24 Revision
June 1, 2015 D4778-15 Revision
Dec. 1, 2010 D4778-10 Revision
Jan. 1, 2005 D4778-05 Revision
Jan. 1, 1999 D4778-94R99E01 Reaffirmation