Logo

ASTM C367/C367M-09

Historical Revision

Standard Test Methods for Strength Properties of Prefabricated Architectural Acoustical Tile or Lay-In Ceiling Panels

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 These test methods cover the determination of the strength properties of prefabricated architectural acoustical tile or lay-in ceiling panels as follows:

1.2 Not all of the tests described in these test methods may be necessary to evaluate any particular product for a specific use. In each instance, it will be necessary to determine which properties are required.

1.3 These test methods specify procedures that may be used in product development, manufacturing control, specification acceptance, and service evaluation.

1.4 Properties determined by these test methods reflect the performance of the materials under the specific conditions of the test, and do not necessarily indicate performance under conditions other than those specified herein.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


Knowledge of hardness is useful in the development and the quality control of acoustical tile and lay-in ceiling panels. Deviation from an established hardness range will assist in pointing out processing errors or defective raw materials, thereby aiding the maintenance of uniform product quality.

This property is also useful in comparing the relative abilities of materials to resist indentations on the panel surface caused by impacts.

Since the hardness varies with the thickness, only samples of the same thickness may be directly compared.

SDO ASTM: ASTM International
Document Number C367
Publication Date Oct. 15, 2009
Language en - English
Page Count 6
Revision Level 09
Supercedes
Committee E33.04
Publish Date Document Id Type View
May 15, 2022 C0367_C0367M-22 Revision
May 1, 2016 C0367_C0367M-16 Revision
Oct. 15, 2009 C0367_C0367M-09 Revision
Jan. 1, 2021 C0367_C0367M-16R21 Reaffirmation